This all started a few weeks ago. A modern sailboat can use a hydraulic system to tension some of the rigging that holds the mast up. On my boat, I have a manual pump to supply the hydraulic oil to the cylinder. It is not uncommon to pump 3 to 4000 psi into the system. The seal on my hydraulic cylinder started leaking during the summer. I started looking for someone to rebuild the cylinder. A prominent rigger suggested an authorized rep in Seattle or just a local hydraulic shop could do it. I called the rep in Seattle, but he did not return my call(the number on the website was an old number he did not use). So I took the cylinder to a local hydraulic shop. They could not get it apart. So, now came Plan B. I found a used one on Ebay and decided to take a chance on it. It arrived and it became immediately apparent that it was in terrible shape plus it had the wrong rod installed and could not be made to work without replacing the rod and replacing the seals. The cost would be as much as a new one. I am still trying to return this cylinder and get reimbursed.
So now, I get a call from the factory rep in Seattle and yes he would be glad to see if he could repair one or both. So I sent both cylinders to Seattle to see what he could do. He possibly would need both cylinders to make one workable one or maybe both would be unusable. After a few days, he called to say that he could rebuild mine, but the Ebay unit had many problems along with the short rod and is pretty much junk and only couple of the parts were any good.
Yesterday I took a bicycle ride to Seattle to pick up the cylinders. The rep lives right at Alki Pt. But first I rode north from the ferry to the north end of Lake Union(near Gasworks Park) to Fisheries Supply for some small boat parts. Then I took a detour to the Ballard Locks. From there I retraced my path to the ferry terminal and continued around Elliot Bay to Alki Point. I loaded up the two cylinders along with two quarts of hydraulic oil and headed back to the ferry. I arrived with enough extra time to buy fish and chips from Ivars. Yum! By the time I rode home from the ferry, I had travelled 44 miles. A good days ride!
Today I took the cylinder down to the boat to install it. First I flushed about a quart of new oil through the pump and hoses. Actually installing the cylinder only too a couple of minutes and then I pressurized the system to 3000 psi a few times to purge any air out.
So even though it is more fun buying glitzy things like fancy electronics for the boat, sometimes the low tech items take priority.
The cylinder from my boat is also fully retracted. Notice the difference?
Cylinder once again installed and leak free!
The large locks at Ballard have been drained for maintenance. I have never seen this before.
The large locks at Ballard have been drained for maintenance. I have never seen this before.
The bike trail heading along Elliot Bay back into Seattle.
Alki Beach.
No comments:
Post a Comment
------------------------------------------------------
Anonymous Users please list their SSN, two Credit Card numbers and Drivers license number before posting. But without identifying yourself, your comment may get removed.